THREAD ROLLING MACHINES
The thread rolling and rolling profiles are part of the process without chips. This technology is used to produce threads, helical gears and toothed on the outside of a piece of work round axial symmetry. On the surface of the workpiece occurs a certain profile will be formed.
It is a rolling process without extremely efficient chips, with one side that- saving steel by fata chip. On the other hand increases surface hardness. Due to the continuous structure of the cold rolled material, you get a workpiece with a higher tensile strength.
- Through-feed System with 2 tools
Aplications
Standard threads, special threads . knurled, ball screws, etc. medium to high precision
Production Rates
From 1 m/min. to 60 m/min.
Sizes of the workpieces
From M2 to M300 in standard steel or high strength, long from 6000mm
- In-feed System with 2 tools
Aplications
Standard threads, special threads . knurled, toothed medium to high precision
Production Rates
1 piece/min until 300 pieces/min
Sizes of the workpieces
From M2 to M300 in standard steel or high strength, along the thread / toothing width = tool
References in rolling are as follows: